VOOPOO PnP X Replacement Coils | 7 Resistances
PnP X is the coil platform behind VOOPOO's current 60W–80W pod mods. Seven resistances run from a wide-open 0.15Ω mesh build for direct-lung clouds down to a dedicated 1.0Ω MTL coil for nicotine salts. Sold singly or in a 5-pack.
Highlights
- Seven resistances, 0.15Ω through 1.0Ω — DTL, RDL and MTL all covered
- Mesh-distributed heating with VOOPOO's thermo-stable cotton, rated to 160°C
- Drop-in install — the coil presses into a PnP X pod, no screw thread
- Goes in PnP X pods, not the original PnP pods
- Buy a single coil or a 5-pack
PnP X coil specs
| Coil | Wattage range | Draw |
|---|---|---|
| 0.15Ω | 60–80W | Direct-lung |
| 0.2Ω | 40–60W | Direct-lung |
| 0.3Ω | 32–40W | Direct-lung / restricted direct-lung |
| 0.45Ω | 25–32W | Restricted direct-lung |
| 0.6Ω | 18–23W | Mouth-to-lung / restricted direct-lung |
| 0.8Ω | 12–16W | Mouth-to-lung |
| 1.0Ω MTL | 10–13W | Mouth-to-lung |
Wattage ranges are VOOPOO's own ratings, printed on each coil. Staying inside the range is most of what coil life comes down to.
Which devices these fit
Any VOOPOO device running a PnP X pod: the Argus PRO 2, Drag X2, Drag S2, Drag X3, and the PnP X versions of the Doric and Argus lines.
Match the coil to the pod, not to the device name. PnP X coils are physically larger than the original PnP coils and only seat in a PnP X pod — if your kit shipped with an original PnP pod, the older PnP coils are what you want. The quick check: a PnP X pod is marked "PnP X" on the body.
Picking a resistance
Work backwards from your juice. Nicotine salts at 25 mg or above want the 0.8Ω or 1.0Ω MTL — they run cool and tight, sip battery, and do not flood you with vapor. Regular 3 mg or 6 mg freebase in a high-VG blend wants 0.3Ω or lower, where the coil has the wattage to actually work.
The 0.45Ω and 0.6Ω are the two most people land on long term. They are warm enough to taste, tight enough to be discreet, and they do not empty a tank in an afternoon.
Making a coil last
Prime it: drip a few drops onto the exposed cotton ports before you seat the coil, fill the pod, then leave it ten minutes. Start at the bottom of the printed wattage range for the first tank and work up. Refill before the pod runs low rather than after — almost every "bad coil" is a coil that got run dry once.
One to two weeks is normal. High-wattage builds wear faster than the MTL coils, and dark, sweetened juice gunks any of them early.
Why buy PnP X coils from Central Vapors
We stock all seven resistances, and we sell singles as well as 5-packs so you can try a resistance before you buy five of it. Central Vapors has been filling vape orders since 2013, and every order is backed by our satisfaction guarantee.
PnP X coils — common questions
| Q |
Which devices do PnP X coils fit? Any device using a PnP X pod — Argus PRO 2, Drag X2, Drag S2, Drag X3, and the PnP X versions of the Doric line. |
| Q |
Are PnP X coils the same as PnP coils? No. PnP X is the newer, larger platform. They look similar but the pods differ, so match the coil to your pod generation rather than to the device's name. |
| Q |
Which coil should I use for nicotine salts? The 0.8Ω at 12–16W or the 1.0Ω MTL at 10–13W. Those are the two tightest, coolest builds in the range and the standard pick for salts. |
| Q |
Which coil gives the biggest clouds? The 0.15Ω, rated 60–80W. You need a device that can actually reach that ceiling and a high-VG juice to keep up with it. |
| Q |
How long should a coil last? One to two weeks with regular use. Prime new coils and stay inside the printed wattage range; high-wattage builds and heavily sweetened juice both shorten it. |
For use by adults 21+.
