Vaporesso XROS 3 Pod System

QHow do I prime a new coil or pod before I use it?

Central Vapors Team · Jun 27, 2026

ASaturate the wick first: add 3–5 drops of e-liquid onto the exposed cotton holes on the coil, install it, fill the tank/pod, then wait 5–10 minutes before your first puff. A few gentle primer puffs (device off, or at low power) help pull liquid into the wick. Always refill before it runs low. This is the #1 way to avoid a burnt taste. — Central Vapors

QMy new coil tastes burnt right away — what's wrong?

Central Vapors Team · Jun 27, 2026

AAlmost always it's an un-primed coil or too-high wattage. Before first use, prime it: put a few drops of e-liquid directly on the cotton wicking holes, fill the tank/pod, and let it sit 5–10 minutes so the cotton fully saturates. Start at the LOW end of the coil's wattage range and work up. Keep your e-liquid above the wicking ports so the coil never runs dry — dry hits are what scorch the cotton. — Central Vapors

QWhat is the battery on the XROS 3?

Central Vapors Team · Jun 27, 2026

AA 1000mAh built-in battery, paired with the AXON chipset and a neon battery-level indicator for consistent flavor. — Central Vapors

QAre XROS 3 pods compatible with older XROS pods?

Central Vapors Team · Jun 27, 2026

AYes — the XROS 3 is compatible with all previous XROS replacement pods. It uses 2ml refillable pods and supports a tight MTL or a looser RDL draw. — Central Vapors