GEEKVAPE Zeus Sub-ohm Tank

QWhy are there several coil options for the same tank, and how do I pick the right one?

Central Vapors Team · Jun 27, 2026

AThey're the same coil family in different resistances (ohms), each tuned for a different style — they all fit the same tank/pod. Lower-ohm coils (about 0.2–0.4Ω) are sub-ohm: run them at higher wattage for warm, big direct-lung clouds. Higher-ohm coils (about 0.8–1.2Ω and up) run at lower wattage for a tighter mouth-to-lung draw, cooler vapor, and longer battery life. So pick the resistance that matches the wattage and draw you like, and stay within each coil's recommended wattage range for the best flavor and coil life. Tip: confirm you're buying the exact coil family your device lists — coil names can differ between device generations. — Central Vapors

QHow do I prime a new coil or pod before I use it?

Central Vapors Team · Jun 27, 2026

ASaturate the wick first: add 3–5 drops of e-liquid onto the exposed cotton holes on the coil, install it, fill the tank/pod, then wait 5–10 minutes before your first puff. A few gentle primer puffs (device off, or at low power) help pull liquid into the wick. Always refill before it runs low. This is the #1 way to avoid a burnt taste. — Central Vapors

QMy new coil tastes burnt right away — what's wrong?

Central Vapors Team · Jun 27, 2026

AAlmost always it's an un-primed coil or too-high wattage. Before first use, prime it: put a few drops of e-liquid directly on the cotton wicking holes, fill the tank/pod, and let it sit 5–10 minutes so the cotton fully saturates. Start at the LOW end of the coil's wattage range and work up. Keep your e-liquid above the wicking ports so the coil never runs dry — dry hits are what scorch the cotton. — Central Vapors

QIs the Zeus tank leakproof and top-fill?

Central Vapors Team · Jun 27, 2026

AYes — the Zeus carries on its leakproof top-airflow design from earlier Zeus tanks, so you get strong flavor with minimal leaking. — Central Vapors

QWhat coils does the GeekVape Zeus Sub-Ohm Tank use?

Central Vapors Team · Jun 27, 2026

AIt uses GeekVape Zeus mesh coil atomizers — including 0.4Ω and 0.2Ω kanthal mesh options — installed from the bottom, with a top airflow control ring. — Central Vapors